Laser distance measurement sensors are powerful and robust instruments
designed to meet the demands of the industrial measurement market. The
Dimetix products provides accurate and contact-less distance measurement
over distances from 50 mm to 500 m (2 inches to 1640 feet).
The target surface may be smooth or rough, wet or dry, dull or high-gloss;
flat, inclined, or round. The measuring range for natural surfaces
is 50 mm to 65 m. A special reflecting target plate increases
the range to 500 m.
Features:
Measuring range: 0.05 m to 500 m
Typical accuracy: ±1.5 mm (DLS-B15), ±3.0 mm (DLS-B30)
Worst-case accuracy: ±2.0 mm (DLS-B15), ±5.0 mm (DLS-B30)
Precision: 0.1 mm
Typical measuring time is 0.15 seconds, longer for some target surfaces
Laser spot size: 8 mm at 10 m, 25 mm at 50 m, and 40 mm at 100 m
Ingress protection IP65 (protected against dust and water)
RS-232 or RS-422 serial interface
Up to 10 units may share a single RS-422 line
Programmable analog output
Two programmable digital outputs
Digital output for error signalling
One programmable digital input
Four status LEDs
Both 15-pin D-sub connector and screw terminal strip may be used for
serial interface and output channels
Flexible power requirements: 9-30 VDC
Low power consumption: 140mA (max) at 24V
Solid aluminum metal housing
Dimensions (Height x Width x Length): 54 x 80 x 153 mm (2.1 x 3.1 x
6.0 in.)
Can be mounted with three M4 screws
Temperature range −10C to +50C (−10C to +45C in continuous
operation)
Expanded-temperature models available for −40C to +50C (−40C
to +45C in continuous operation)
Complimentary configuration software available
Options and accessories:
Telescopic viewfinder, to help with long-distance measurements
Target plates, orange on aluminum (210 x 297 mm,
8.3 x 11.7 in.), needed for target distances greater than 65m (213 ft.)
Laser glasses — red filter makes the laser beam spot easier to
see in bright environments. These glasses are not for eye protection, but to help see the beam better. For safety, do not look directly into the beam.
IP65 15-pin D-sub protective connector cover
IP65 90° cable exit connector and protective cover
Model
selection:
±1.5 mm
accuracy
±3.0 mm
accuracy
−10C to +50C
DLS-B15
DLS-B30
−40C to +50C
DLS-BH15
DLS-BH30
Laser lifetime is better than five years at +20C. Laser
lifetime is reduced at higher operating temperatures.
Uses a red laser diode, 620-690 nm, less than 0.95 mW. Class
II laser product. Very brief exposure to the direct laser beam is
considered non-harmful. Do not stare into the laser beam.
AZ
Measurement
